Let's start building a glass sprinkler, a plastic kettle, a motor, three pipes, three sprinklers, that's all.

　　塑料水壺儲存水，馬達泵水，軟管輸送水，灑水器噴水。不是那么容易

　　Plastic kettles store water, motor pumps, hoses deliver water, sprinklers spray water. It's not that easy.

　　汽車的玻璃會像杯子里的水一樣結冰。如果你加熱太快，它不會融化，水壺可能會破裂，所以不要加熱水。我相信你們都知道這個事實。

　　The glass of a car will freeze like water in a glass. If you heat too fast, it won't melt and the kettle may burst, so don't heat the water. I believe you all know this fact.

　　玻璃水使溶液結冰

　　Glass water freezes the solution

　　凍結玻璃的最好方法是讓它跑到陽光下，啟動引擎，然后在太陽和引擎的溫度下融化。

　　The best way to freeze glass is to let it run into the sun, start the engine, and then melt in the sun and the engine temperature.

　　解凍后及時更換防凍玻璃排水玻璃水的方法

　　Method of Replacing Antifreeze Glass Drainage Glass Water in Time after Thawing

　　那么如何處理掉原來的玻璃呢?

　　So how to deal with the original glass?

　　有些人選擇不噴水，這對電機是非常損壞的，它很可能對電機造成損壞，是不值得損失的。其實，把玻璃水壺放在地上移開水管排水就不會那么麻煩了，找不到水管的位置就可以看看水壺旁邊，或者拿一根水管吸出來。

　　Some people choose not to spray water, which is very damaging to the motor, it is likely to cause damage to the motor, is not worth losing. In fact, the glass kettle on the ground to remove the water pipe drainage will not be so troublesome, can not find the location of the water pipe can look at the kettle next to, or take a water pipe to suck out.

　　玻璃水凍車概述，有三點需要注意:

　　There are three points to be paid attention to in the summary of glass water freezing car.

　　1. 不要把水加熱解凍，否則水壺會爆裂。

　　1. Don't thaw the water by heating, otherwise the kettle will burst.

　　2、不要頻繁啟動噴水電機，小心電機燒壞(不允許冷凍和排水)。

　　2. Don't start the sprinkler motor frequently. Be careful that the motor burns out (freezing and drainage are not allowed).

　　及時更換防凍玻璃水。

　　Replace antifreeze glass water in time.

　　最后提醒，為了防止玻璃水再次結冰，必須更換防凍玻璃水。

　　Finally, it is reminded that in order to prevent the glass water from freezing again, it is necessary to replace the anti-freezing glass water.